%
0.01% to 1.00%
%
Up to 3.00%
%
0.01% to 1.00%
min
1 to 1,440 minutes
The LP fee starts at 0.30%. Each 1% the price moves within 10 min adds 0.10%, up to 1.00%, then it eases back.
Hook Studio · v1
Build a v4 hook. Keep it running.
Pick tested blocks, set their limits, watch them run against real swaps, then deploy the hook and its pool from your own wallet.This builds the hook itself. To set up automations around a hook you already have, use Describe it on New automation.
01Build
Each block is locked in when the hook deploys. The limits on every input are the contract's own.
Two ways in
Gets the creator share and anything left over when fees are paid out.
Connect a wallet to use it, or paste the creator address.
%
%
Up to 0.50%
%
Optional
All three together: at most 3.00% of each swap.
Only needed with a treasury share. The builder share always goes to the wallet that deploys.
Every swap pays 0.25% of its input to the hook: 0.20% to the creator, 0.05% to the builder, the wallet that deploys it. Payouts only ever go to these addresses.
02Simulate
Runs your config against a list of swaps with the same math the contract uses. Every number below comes from the simulator.
Scenario
Mixed buys and sells of 0.01% to 1% of the pool, every 12 seconds to 2 minutes.
Correct the highlighted inputs to simulate.
Pick a scenario and run it to see each swap.
03Review
Unaudited starting point — keep pools small until reviewed.
ComposableHook has tests and hard limits, but no outside audit yet. Its behaviour can't change after deploy: no admin key, no upgrade, no withdraw of swapper funds.
Correct the highlighted inputs to simulate.
04Deploy
One transaction from your wallet deploys the hook at an address that encodes its permissions and initializes an ETH pool with it. Conductor never deploys with its own keys.
Checking for a wallet…
tokens per ETH
Correct the highlighted inputs to simulate.